TM 55-1520-240-23-3
4-111
INSTALL ACTUATOR SUPPORT BRACKET
4-111
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Powerplant Repairers Tool Kit, NSN
5180-00-323-4944
Torque Wrench, 5 to 50 Inch-Pounds
Materials:
None
Personnel Required:
Aircraft Powerplant Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
Procedure is same to install actuator
support bracket on No. 1 or No. 2
engine. No. 1 engine is shown here.
1.
Make sure gasket (1) is in serviceable condition.
2.
Position bracket (2) on studs (3). Install four
washers (4) and nuts (5) on studs.
3.
Torque four nuts (5) to 35 inch-pounds.
INSPECT
FOLLOW-ON MAINTENANCE:
Install gas producer control actuator (Task 4-109).
Install power turbine control actuator (Task 4-139).
Close engine access cover (Task 4-50).
Close engine work platform (Task 2-2).
END OF TASK
4-396