TM 55-1520-240-23-3
4-108
REMOVE GAS PRODUCER CONTROL ACTUATOR
4-108
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Powerplant Repairers Tool Kit, NSN
5180-00-323-4944
Materials:
None
Personnel Required:
Aircraft Powerplant Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Engine Work Platform Open (Task 2-2)
Engine Access Cover Open (Task 4-49)
NOTE
Procedure is same to remove gas
producer control actuator from No.
1 or No. 2 engine. No. 1 engine is
shown here.
1.
Disconnect cable connector (1) from actuator (2).
2.
Remove nut (3) and washer (4). Slide lever (5)
off shaft (6). Move rod (7) up and aft.
4-392