TM 55-1520-240-23-9
11-211
INSPECT FORWARD LCT YOKE
(Continued)
11-211
8.
Install dial indicator (1) over forward bearing
housing (8).
9.
Grasp yoke (4) at bearing housing (8). Try to
move yoke up and down. Do not rotate yoke.
Record vertical movement.
10.
Vertical movement at either bearing housing (7
and 8) must be less than .007 inch. If vertical
movement is more than .007 inch, check yoke
(4) for correct installation (Task 11-217).
11.
Connect actuator (5) and connecting link (6) to
yoke (4) (Task 11-217).
12.
Apply hydraulic power.
13.
Repeat steps 3 and 4.
14.
Inspect yoke (4) for nicks, scratches, and gouges,
as follows:
a.
In critical areas (9), V-bottom scratches or
ragged gouges shall not be deeper than
0.003 inch. Round-bottom scratches, gouges
or nicks shall not be deeper than 0.010 inch.
b.
In non-critical areas (10), V-bottom scratches
or ragged gouges shall not be deeper
than 0.010 inch. Round-bottom scratches,
gouges, or nicks shall not be deeper than
0.030 inch.
15.
Remove electrical power.
FOLLOW-ON MAINTENANCE:
Close forward work platforms (Task 2-2).
END OF TASK
11-838
