TM 55-1520-240-23-9
11-155
DISASSEMBLE THRUST CCD ACTUATOR (AVIM)
(Continued)
11-155
9.
Remove two screws (1) and washers (2) from
receptacle (3). Remove receptacle. Heat screw
heads. Use soldering gun.
10.
Tag and unsolder 13 wires (19) from receptacle
(3).
11.
Remove screw (20) and washer (21) from bracket
(22).
12.
Remove two screws (23) and washers (24) from
bracket (22) and chassis (7). Remove bracket.
13.
Remove bearing (25) from bracket (22).
14.
Remove two screws (26) from clamp (27) and
bracket (28). Remove clamp, bracket, and
magnet (29).
15.
Loosen two setscrews (30) from disc (31).
Remove disc.
16.
Tag and unsolder five wires (32) of servo motor
(33) from wire harness (34).
17.
Remove three screws (35), washers (36), and
clamps (37) from gear plate (38). Remove motor
(33).
11-637