TM 55-1520-240-23-9
11-157
ASSEMBLE THRUST CCD ACTUATOR (AVIM)
(Continued)
11-157
1.
Install servo motor (1) in gear plate (2). Align
wires (3) of motor and wires (4) of harness (5).
2.
Install three clamps (6), washers (7), and screws
(8) in plate (2).
3.
Solder five wires (4) to wires (3). Use sleeving
(E204), solder (E360), and soldering gun.
Remove tags.
4.
Solder six wires (9) to terminal board (10). Use
sleeving (E204), solder (E360), and soldering
gun. Remove tags.
5.
Solder two wires (11) to terminal board (12). Use
sleeving (E204), solder (E360), and soldering
gun. Remove tags.
6.
Position board (10) on chassis (13). Install two
screws (14) and washers (15) in chassis and
board.
7.
Position board (12) on chassis (13). Install two
screws (16) and washers (17) in chassis and
board.
8.
Solder 13 wires (18) to terminals (19) of
receptacle (20). Use sleeving (E204), solder
(E360), and soldering gun. Remove tags.
9.
Position receptacle (20) on chassis (13). Install
two washers (21) and screws (22).
11-641
