TM 55-1520-240-23-9
11-154
REMOVE THRUST CCD ACTUATOR
(Continued)
11-154
1.
Tag and disconnect connector (1) from thrust
CCD actuator (2).
2.
Disconnect spring (3) from arm (4) of actuator
(2) (Task 11-131).
3.
Remove cotter pin (5), nut (6), two washers (7),
and bolt (8) from arm (4). Disconnect link (9) from
arm. Install bolt, washers and nut loosely in link.
Tie link away from actuator. Use twine (E433).
4.
Remove bolt (10) and washer (11) from stop
(12). Loosen bolt (13) of stop.
5.
Remove three bolts (14) and washers (15) from
actuator (2). Remove actuator. Lift inboard end
(16) up to release support (17) from stop (12).
6.
Remove lockwire from four bolts (18).
7.
Remove four bolts (18) and washers (19) from
support (17). Remove support from actuator (2).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-635