TM 55-1520-240-23-9
11-94
INSTALL YAW IDLER BELLCRANK
(Continued)
11-94
3.
Remove nut (10), two washers (11 and 12), and
bolt (13) from bellcrank (7).
3.1.
Remove slipfit bushings (7.1) from lugs (9) of
bellcrank (7). Clean bushings with dry cleaning
solvent (E162) and clean cloth (E120). Wear
gloves (E184.1) and goggles.
3.2.
Coat bushings (7.1) with epoxy primer (E292).
Install bushings in lugs (9) of bellcrank (7).
4.
Position transducer (14) between lugs (9) of
bellcrank (7). Install bolt (13), two washers (12
and 11) and nut (10). Do not torque nut at this
time.
5.
Remove nut (15), two washers (16 and 17), and
bolt (18) from bellcrank (7).
5.1.
Remove slipfit bushings (17.1) from bellcrank (7).
Clean bushings with dry cleaning solvent (E162)
and clean cloth (E120). Wear gloves (E184.1)
and goggles.
5.2.
Coat bushings (17.1) with epoxy primer (E292).
Install bushings in bellcrank (7).
11-497