TM 55-1520-240-23-9
11-83
REMOVE STICK PITCH POSITION INDICATOR
(Continued)
11-83
Wires must not support housing;
otherwise, damage to equipment
could occur.
2.
Remove right landing light housing (4) from
access (5). Support housing so it does not hang
by wires (6).
3.
Remove gasket (7) from housing (4).
4.
Strap housing (4) to access (5) at aft end with
strap (E376) (8). Wires (6) must not support
housing.
5.
Working through right access (5), remove cotter
pin (9), nut (10), three washers (11), and bolt
(12) from bellcrank (13).
6.
Disconnect indicator (14) from bellcrank (13).
7.
Working through right access (5), remove
lockwire from bearing (15) and tube (16) of
indicator (14).
8.
Remove bearing (15) from tube (16) of indicator
(14). Turn counterclockwise.
9.
Slide tube (16) forward for access to cable (17)
and collet (18). Remove collet from cable of
indicator (14). Turn counterclockwise.
11-439