TM 55-1520-240-23-9
11-81
INSTALL PILOT’S COCKPIT CONTROL ASSEMBLY
11-81
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 30 to 150 Inch-Pounds
Materials:
Acetone (E20)
Cloths (E120)
Sealant (E336)
Gloves (E186)
Parts:
Gasket
Cotter Pins
Personnel Required:
Medium Helicopter Repairer (2)
Inspector
References:
TM 55-1520-240-23P
Task 1-13
Task 11-33
Task 11-71
INSTALL CONTROL ASSEMBLY
Control assembly weighs about 50
pounds. Do not drop, injury to
personnel or damage to equipment
could occur.
1.
Position control assembly (1) about 6 inches
forward in floor recess (2).
2.
Lift forward end (3) about 6 inches, and tilt left
side (4) down into recess (2). Move assembly
(1) aft and lower forward end. Align assembly
in recess.
3.
Install four washers (5) and bolts (6).
11-420
