TM 55-1520-240-23-9
11-77
ASSEMBLE PILOT’S COCKPIT CONTROL ASSEMBLY
(Continued)
11-77
100.
Install pedal (167) on shaft (191), lug (197)
inward until it bottoms.
101.
Install retainer (198) on shaft (191). Use retaining
ring pliers.
102.
Position spring (199) between lugs (178 and 200)
of post (179).
103.
Install pin (201) in lug (178) and through spring
(199).
104.
Position lever (171) on aft side of lug (202) of
post (179), with channel (172) between lug (178
and 200).
105.
Install bolt (203), three washers (204, 205, and
206), and nut (207). Tighten nut until lever does
not move forward or aft but rotates freely. Back
off nut to align cotter pin hole.
106.
Check gap between washer (206) and lug (202).
Gap shall be 0.010 inch maximum.
107.
Install cotter pin (208).
INSPECT
ASSEMBLE LEFT AND RIGHT ARMS
108.
Install bushing (dissimilar metals) (209) in right
lug of arm (210), flange inward.
109.
Install bushing (dissimilar metals) (211) in left lug
of arm (212), flange inward.
110.
Install bushing (dissimilar metals) (213) in left
lug of arm (210).
111.
Install bushing (dissimilar metals) (214), in right
lug of arm (212).
INSPECT
11-372
