TM 55-1520-240-23-9
11-77
ASSEMBLE PILOT’S COCKPIT CONTROL ASSEMBLY
(Continued)
11-77
INSPECT
90.
Install bushing (dissimilar metals) (170) in lever
(171) until flush.
91.
Position channel (172) on flat surface (173) of
lever (171). Install two bolts (dissimilar metals)
(174), four washers (175), and nuts (176).
INSPECT
92.
Install bushing (dissimilar metals) (177) in right
lug (178) of post (179).
93.
Install bolt (dissimilar metals) (180) two washers
(dissimilar metals) (181 and 182) and nut (183)
in post (179), hole (184) horizontal.
94.
Torque nut (183) to 15 to 20 inch-pounds.
Install cotter pin (185).
95.
Install pin (dissimilar metals) (186) two washers
(dissimilar metals) (187 and 188) and nut (189)
in post (179). Use gun heater.
96.
Torque nut (189) to 30 to 60 inch-pounds.
Install cotter pin (190).
97.
Install shaft (dissimilar metals) (191) in post
(179), holes aligned, until it bottoms. Use gun
heater.
98.
Install bolt (dissimilar metals) (192) two washers
(dissimilar metals) (193 and 194) and nut (195)
in post (179).
99.
Torque nut (195) to 15 to 20 inch-pounds.
Install cotter pin (196).
INSPECT
11-371
