TM 55-1520-240-23-8
10-44
INSTALL MAIN FUEL TANK VENT ASSEMBLY
(Continued)
10-44
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
Procedure is same to install No. 1 and
No. 2 main fuel tank vent assembly.
Installation of No. 1 (left) main fuel
tank vent assembly is shown here.
1.
Remove barrier material and tape from forward
access hole (1) and aft access hole (2). Remove
tape residue from face of tank. Use dry cleaning
solvent (E162) and cloths (E135). Wear goggles
to protect eyes. Wear gloves (E186).
2.
Remove plugs from vent assembly (3) guide
vent assembly into fuel cell (4) through forward
access hole (1). Make sure air vent tube (5) is
at forward end of cell.
3.
Deleted.
4.
Position vent assembly (3) between brackets (8).
Adjust brackets as needed.
5.
Install four screws (9), washers (10), and nuts
(11).
6.
Deleted.
7.
Install washer (12), screw (13), and spacer (14)
on fuel cell (4).
8.
Install screw (15), spacer tube (16), washer (17),
nut (18), and pipe clamp (19) on bracket (20).
9.
Install two screws (21), washers (22), and nuts
(23), through electrical cable clamp (24) and
tube clamp (25).
10-221
