TM 55-1520-240-23-7
9-123
INSTALL TROOP/JUMP SIGNAL OR POSITION LIGHT DIMMING
RESISTORS
(Continued)
9-123
NOTE
Procedure is same to install
troop/jump or position light dimming
resistor. Installation of troop/jump
dimming resistor is shown here.
1.
Install two spacers (1), two resistors (2), washers
(3), and screws (4) on panel (5).
2.
Remove tape from four wires (6). Solder wires
to resistors (2). Remove tags.
INSPECT
3.
Raise panel (7). Install two bolts (8) and washers
(9).
FOLLOW-ON MAINTENANCE:
Perform operational check (TM 55-1520-240-T).
END OF TASK
9-468
