TM 55-1520-240-23-7
9-122
REMOVE TROOP/JUMP SIGNAL OR POSITION LIGHT DIMMING
RESISTORS
(Continued)
9-122
NOTE
Procedure is same to install
troop/jump or position light dimming
resistor. Installation of troop/jump
dimming resistor is shown here.
1.
Remove two bolts (1) and washers (2) from panel
(3). Lower panel.
2.
Tag and unsolder four wires (4) from resistors (5
and 6). Tape wire ends.
3.
Remove two screws (7), washers (8), and
spacers (9).
4.
Remove two resistors (5 and 6).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
9-466