TM 55-1520-240-23-7
9-121
INSTALL TROOP WARNING BOX
(Continued)
9-121
2.
Loosen four screws (5). Have helper hold cover
(6).
3.
Route harness (7) through lower grommet (8)
into box (1).
4.
On forward box (1) only, remove tape and solder
four wires (9) to resistors (10). Remove tags
from wires.
5.
On forward box (1) only, remove tape from wire
terminals (11). Connect 12 wire terminals to
relay (12). Install 12 screws (13) and washers
(14). Remove tags from wires.
6.
Remove nut (19) and washer (18) from ground
stud (17).
7.
Remove tape and connect two wires (15) over
electrical lead (16) to ground stud (17). Install
washer (18) and nut (19). Remove tags.
8.
Disconnect connectors (20) from light (21).
9.
Have helper hold connectors (20). Remove tape
from wires (22) and install wires through back
of connector.
10.
Solder wires (22) to connector (20). Use solder
(E360). Remove tags.
11.
Connect two connectors (20) to lights (21).
9-463