TM 55-1520-240-23-7
9-100
INSTALL OVERHEAD PANEL PANELS
(Continued)
9-100
LTG PANEL
3.
Install LTG panel as follows:
a.
Position panel (14) on panel (2). Tighten four
screws (15).
b.
Remove tape. Connect 15 wires (16) to two
switches (17) by installing washers (18) and
screws (19). Remove tags.
c.
Remove tape. Connect and solder two wires
(30) to two lamps (31). Remove tags. Use
solder (E360).
d.
Remove tape. Connect and solder 19 wires
(22) to two potentiometers (23). Use solder
(E360).
e.
Operate controls (24 and 25) through
full range. Wires must not touch moving
components.
INSPECT
NOTE
If no other panels are to be replaced,
go to step 13.
9-391
