TM 55-1520-240-23-7
9-98.3
REPAIR OVERHEAD PANELS
(Continued)
9-98.3
PRESS-TO-TEST LIGHT ASSEMBLIES
NOTE
Press-to-test light assemblies are
on the FUEL CONTROL, ENGINE
START, and TROOP WARN/HEATING
panels. All are replaced in the same
manner. TROOP WARN/HEATING
panel shown here.
8.
Remove light assembly (35) as follows:
a.
Remove lightplate (12). (Refer to step 2.)
b.
Remove cap (36) and bulb (37).
c.
Turn fasteners (20) 1/4 turn counterclockwise.
Pull panel (8) away from overhead panel (1),
far enough to gain access to assembly (35).
d.
Tag wires (38). Use tags (E264). Cut wires
close to soldered joints.
e.
Remove nut (39) at front of panel (8).
Remove assembly (35).
9.
Install light assembly (35) as follows:
a.
Remove cap (36), bulb (37), and nut (39)
from serviceable assembly (35). Adjust
locknut (40) to same position as on removed
assembly.
b.
Insert assembly (35) through back of panel
(8). Install nut (39) from front of panel.
c.
Solder wires (38) to lugs on assembly (35).
Use heat-shrinkable tubing over connections.
Remove tags from wires.
d.
Install bulb (37) and cap (36).
e.
Position panel (8) on overhead panel (1).
Turn fasteners (20) 1/4 turn clockwise to
secure panel.
f.
Install lightplate (12). (Refer to step 3.)
FOLLOW-ON MAINTENANCE:
None
END OF TASK
9-350
