TM 55-1520-240-23-7
9-75
ASSEMBLE LANDING LIGHT ROTATING MECHANISM (AVIM)
(Continued)
9-75
4.
Install two bearings (11). Use arbor press.
5.
Install bearing (12), spacer (13), and bearing
(14). Use arbor press.
6.
Install two bearings (15). Use arbor press.
7.
Lubricate shaft (2) by coating lightly with oil. Use
lubricating oil (E257). Install shaft in casting (16).
8.
Lubricate worm and shaft (17) by coating lightly
with oil. Use lubricating oil (E257). Install worm
and shaft in casting (16).
9.
Lubricate gear (18) by coating lightly with oil. Use
lubricating oil (E257). Install gear on shaft end of
worm and shaft (17). Install two setscrews (19).
10.
Install insulator (20), screw (21), two washers
(22), and stud (23).
11.
Install contact (24), screw (25), and washer (26).
12.
Install screw (27), washer (28), and post (29).
13.
Install clamp (30), two screws (31), and washers
(32).
14.
Install two posts (33), adjusting plate (34), two
screws (35), two flat washers (36), and two lock
washers (37).
15.
Install switch (38), adapter (39), and insulator
(40) using two screws (41) and washers (42).
9-252
