TM 55-1520-240-23-7
9-25.3
INSTALL BATTERY CABLE (AVIM)
9-25.3
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electrical Repairers Tool Kit, NSN 5180-00-323-4915
Battery Service Tool Kit, NSN 5180-00-542-5812
Materials:
Lockwire (E231)
Corrosion Preventive Compound (E153)
Personnel Required:
Aircraft Electrician
References:
TM 11-6140-203-14-2
Equipment Condition:
Off Helicopter Task
Battery Cleaned, Discharged, and Shorting Strips
Installed
1.
Remove all shorting strips. Refer to TM
11-6140-203-14-2.
2.
Install connector (1) in hole in battery case
(2). Install locknut (3) and tighten to 50 to 60
inch-pounds.
3.
Lockwire nut (3) to lockwire tab (5) on battery
case. Use lockwire (E231).
4.
Install U-shaped liner (6).
5.
Install battery cell (7).
Refer to TM
11-6140-203-14-2. Ensure + terminal is directly
behind + post on battery connector (8).
Improper installation or connection
of cable assembly could result in
damage to cable assembly and
battery.
9-76