REPLACE FUEL QUANTITY SYSTEM COAXIAL CONNECTOR CONTACTS (Continued)

REPLACE FUEL QUANTITY SYSTEM COAXIAL CONNECTOR CONTACTS (Continued) - TM-55-1520-240-23-7_283

REPLACE FUEL QUANTITY SYSTEM COAXIAL CONNECTOR CONTACTS (Continued) - TM-55-1520-240-23-7_285

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
258

TM 55-1520-240-23-7 8-82.1 REPLACE FUEL QUANTITY SYSTEM COAXIAL CONNECTOR CONTACTS (Continued) 8-82.1 26. Install contact separator (29) on inner contact (30) flush with end of wire barrel (31). NOTE If required, trim cable inner conductor in order to butt end of contact wire against cable dielectric before crimping. 27. Install inner contact (30) on inner conductor (28) with end of wire barrel (31) against dielectric (27). 28. Crimp inner contact (30). Use crimper MH800 with locator K269. Do not exert more than 1 pound pressure to seat inner contact. Damage to contact could occur. NOTE After seating inner contact on cable, support contact and cable until crimp sleeve is installed to prevent strain on inner contact crimp joint. 29. Push inner contact (30) onto contact outer body (32) until inner contact seats. 8-268

Privacy Statement
Press Release
Contact