TM 55-1520-240-23-7
8-82.1
REPLACE FUEL QUANTITY SYSTEM COAXIAL CONNECTOR CONTACTS
(Continued)
8-82.1
Cable Preparation
7.
Prepare coaxial cable (8) by removing outer
jacket (9), shield (10), and dielectric (11) to
dimensions shown.
8.
Tin coaxial cable center conductor (12). Use
solder (E360).
9.
Install contact (13) carefully over end of prepared
cable (8). Push contact gently, while twisting it
onto cable until it seats.
10.
Check that the center conductor (12) is visible
through the forward inspection hole (14). Also,
check that the shield braid (15) is visible through
the rear inspection window (16).
11.
Check that the spacing between the end of the
contact body (17) and the cable jacket insulation
(9) does not exceed 7/64 inch.
8-265
