TM 55-1520-240-23-7
9-160
ASSEMBLE WINCH CONTROL GRIP (AVIM)
(Continued)
9-160
1.
Position switch (1) on plate (2). Install washer
(3) and nut (4).
2.
Install screw (5), spacer (6), arm (7), switch (8),
washer (9), lockwasher (10), and nut (11) on
plate (2).
3.
Position gear (12) on shaft (13). Install three
screws (14) loosely.
4.
Position bearing (15) to gear (12). Install two
screws (16).
5.
Install spring (17) with longer tang towards shaft
gear (18).
6.
Install shaft (19) on shaft (18). Install screw (20).
Position plate (21) on shaft (19).
7.
Position shaft (19) in handle. Install screw (22),
washer (23), screw (24), and washer (25).
8.
Position knob (26) on shaft (18). Install screw
(27).
9.
Set knob to OFF. Mate shaft (18), gear (28) to
gear (12). Check groove in gear (12) is engaged
by roller of arm (7).
10.
Set switch (1) to mid-range. Tighten three screws
(14).
11.
Adjust bearing (12) for proper mesh by adjusting
screws (16). Coat screws with Zinlac (E456).
9-640