TM 55-1520-240-23-6
7-97
EXTENSIBLE LINK ACTUATOR CYLINDER FUNCTIONAL TEST (AVIM)
7-97
INITIAL SETUP
Applicable Configurations:
All
Tools:
Integrated Lower Controls Actuator Bench Test Set
145GS278-1
Power Source, 115 Volt, 60 Hz AC
Hydraulic Test Stand D5 or Equivalent
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Safety Ground Cable
Stopwatch
Materials:
Acetone (E20)
Cloths (E135)
Lockwire (E231)
Screws NAS1351-4-4H14P
Gloves (E186)
Parts:
Preformed Packings
Screws (3)
Personnel Required:
Avionic Navigation and Flight Control Equipment
Repairer
Aircraft Pneudraulics Repairer
Inspector
References:
TM 55-1520-240-23P
Equipment Condition:
Off Helicopter Task
Integrated Lower Control
Actuator Bench Test Set Prepared for Use (TM
55-4920-428-13)
General Safety Instructions:
Hydraulic fluid (E199) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Wear face shields throughout
these tests. Hydraulic fluid ejected
under pressure can cause injury to
personnel. Hydraulic fluid sprayed
into the air is a fire hazard.
7-377
