TM 55-1520-240-23-6
7-19
ASSEMBLE FILL MODULE (AVIM)
(Continued)
7-19
ASSEMBLE HANDLE
53.
Install three bushings (69) in handle (70).
54.
Position handle (70) in housing (22). Install
sleeve (71) through housing and handle.
55.
Install bolt (72) and nut (73). Tighten nut
finger-tight.
56.
Position two links (74) on piston (26). Install
bolt (75) and nut (76). Turn piston to install bolt.
Tighten nut finger-tight.
57.
Position handle (70) between link (74). Install
bolt (77) and nut (78). Tighten nut finger-tight.
58.
Back off nuts (73, 76 and 78), and align nearest
nut slot and bolt hole. Install cotter pins (79, 80
and 81).
59.
Check handle (70). Handle shall be free to move.
INSPECT
FOLLOW-ON MAINTENANCE:
Test fill module (Task 7-20).
END OF TASK
7-145
