TM 55-1520-240-23-6
7-320
FLUSH HOIST CONTROL RETURN TUBING
(Continued)
7-320
Filter assembly kit
ADHT6814-M9716M must be
installed in test stand pressure line.
NOTE
To operate hydraulic test stand, refer
to applicable manual.
1.
Disconnect tube (1) from tee (2).
2.
Connect test stand pressure hose (3) to tube (1).
3.
Disconnect tube (1) from relief valve (4).
4.
Connect hose (5) to tube (1).
5.
Disconnect CD hose (6) from motor (7).
6.
Connect hose (5) to hose (6).
7.
Connect test stand return hose (8) to tube (9).
8.
Install plug (10) to tube (11).
Do not exceed 500 psi. Otherwise
damage to components can occur.
Keep test stand bypass valve closed.
Otherwise, contaminants could
re-enter the system.
9.
Apply hydraulic power. Set stand to 10 gpm at
500 psi. Flush system for 15 minutes. Check
for leaks.
10.
Remove hydraulic power.
7-1150