TM 55-1520-240-23-5
6-182
REMOVE COMBINING TRANSMISSION OIL COOLER FAN AND SHAFT (Continued)
6-182
3.
Remove four nuts (4), washers (5), and bracket
(6) from fan (3).
NOTE
The drive shaft may come out with the
fan or stay in the transmission. The
shaft is about 30 inches long.
4.
Lift fan (3) straight up until drive shaft (7) clears
cooler (8). Remove shaft from baffle (9) or fan.
Identify the upper end of the drive shaft with tape
or marker.
5.
On helicopters (Without 66 ), remove two
packings (10) from shaft (7).
CAUTION
After removal of retaining shield,
reinstall nuts on studs to hold the
transmission gear cartridge in place.
Tighten nuts not to exceed 60
inch-pounds.
6.
Remove retaining shield (11) (Task 6-184).
7.
Remove adapters (12) from the splines of drive
gear (13) and fan shaft (14).
FOLLOW-ON MAINTENANCE:
Inspect combing transmission oil cooler fan assembly
and fan drive shaft (Task 6-182.1).
END OF TASK
Change 1
6-597