TM 55-1520-240-23-5
6-51
INSTALL FORWARD TRANSMISSION PACKAGE
(Continued)
6-51
9.1.
Torque aft bolt (16.1) as follows:
a.
Install socket assembly (14.1) on aft bolt
(16.1).
b.
Install torque applicator (15) over square
drive of socket assembly (14.1) with large
hole at left of assembly. Observe THIS SIDE
UP stamping on applicator.
c.
Install left end of applicator (15) in end block
(16.9) of reactor (16). Install socket at end of
reactor on left bolt (14).
d.
Install pin (16.2) through end block (16.9) and
applicator (15).
e.
Check that ratchet selector (15.4) on torque
pack (T23) (16.4) is set to NUT ON.
f.
Install torque pack (T23) (16.4) on square
drive of socket assembly (14.1). Rotate pack
so that two pins (16.5) on bottom fit into holes
(16.6) in applicator (15). Use handle (T161)
(16.7).
Be sure handle is fully seated and
ratchet selector on torque pack is
properly set before applying torque.
Moving selector with load on torque
pack can damage unit and injure
personnel.
NOTE
Input force must be maintained at
handle to obtain accurate torque
reading on torque pack indicator.
g.
Set tee handle (T161) (16.7) to ON. Turn
handle clockwise until indicator (16.8) reads
885 foot-pounds.
h.
Set tee handle (T161) (16.7) to OFF. Turn
handle (16.7) counterclockwise until indicator
(16.8) reads 0. Check that torque pack (T23)
(16.4) is loose on bolt (16.1).
i.
Remove torque pack (16.4) and torque
reactor assembly (T159).
6-195
