TM 55-1520-240-23-4
5-124
INSTALL SWASHPLATE SLIDING SLEEVE BEARING (AVIM)
(Continued)
5-124
12.
Check installation of three retainers (8) as
follows:
a.
Loosen six screws (9).
b.
Hold each retainer (8) firmly against
segments (2 and 3).
Do not turn lockwire ends inboard of
bolt heads. Make sure retainers are
not inboard of sleeve bearing surface.
Contact with lockwire or retainer will
damage slider shaft.
c.
Torque screws (9) to 15 inch-pounds.
Lockwire screws. Use lockwire (E231). Tuck
end under crosswire.
13.
Clean adhesive from bearing (1). Use cloth
(E120) damp with methyl-ethyl-ketone (E244).
Use soft aluminum scraper, if needed. Wear
gloves (E186).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
5-686