TM 55-1520-240-23-4
5-124
INSTALL SWASHPLATE SLIDING SLEEVE BEARING (AVIM)
(Continued)
5-124
9.
Install bearing (1) on locating fixture (T110) (11)
as follows:
a.
Rest fixture (T110) (11) on flat surface.
b.
Pull three clamps (12) and three supports
(13) toward center.
c.
Align spherical bearing (1) so three gaps (7)
center on three handknobs (14). Rest bearing
on three feet (15) of fixture (T110) (11).
d.
Push three supports (13) and three clamps
(12) outboard under slots. Turn three
handknobs (14) clockwise to tighten clamps.
e.
Remove adhesive squeeze out from spherical
bearing (1). Use cloth (E120) damp with dry
cleaning solvent (E162). Wear gloves (E186).
f.
Allow adhesive to cure 24 hours.
g.
Loosen handknobs (14). Pull clamps (12) and
supports (13) inward until clear of bearing (1).
h.
Remove bearing (1) from fixture (T110) (11).
10.
Check that location and spacing of six segments
(2 and 3) is as described in step 8a.
11.
Check inside diameter across segments (2 and
3). Inside diameter shall be 10.745 to 10.755
inches.
5-685
