TM 55-1520-240-23-4
5-88.2
INSTALL SHOCK ABSORBER ROD END BEARING (AVIM)
5-88.2
INITIAL SETUP
Applicable Configurations:
Without
45
Tools:
Technical Inspection Tool Kit, NSN 5180-00-323-5114
Arbor Press
Pusher (APP E-41)
Styrofoam Container or Equivalent
Vise, Soft Jaws
Dial Indicating Scale, 0 to 100 Pounds
Torque Wrench, 0 to 150 Inch-Pounds
Materials:
Gloves (E186)
Solvent (E162)
Cloths (E120)
Kevlar Gloves (E187)
Dry Ice (E92)
Methanol (E243)
Liquid Nitrogen (E247) (Alternate Coolant)
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1500-322-24
TM 55-1520-240-23P
General Safety Instructions:
Carbon dioxide (dry ice) (E92) in
methanol (E243) is flammable,
causes severe burns (frost bite), and
gives off toxic fumes. Use only in
well-ventilated area, away from heat
and open flame. Do not get in eyes,
on skin, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Liquid nitrogen (E247) causes severe
burns (frost bite). Do not get in eyes,
on skin, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Wear Kevlar gloves (E187) when
handling chilled parts. Chilled parts
can injure unprotected skin.
Dry cleaning solvent (E162) is
combustible and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
5-535
