TM 55-1520-240-23-4
5-81
INSTALL TIEDOWN RECEIVER
5-81
INITIAL SETUP
Applicable Configurations:
All
Tools:
Airframe Repairer’s Tool Kit, NSN 5180-00-323-4876
Tiedown Receiver Tool (T25)
Drive Handle, 1/2 Inch
Source of Compressed Air
Heat Lamp
Trip Balance, NSN 6670-00-401-7195
Materials:
Adhesive (E40, E41 or E43)
Gloves (E186)
Temperature Indicating Strips (E413)
Wood Spatula (E424)
Polyethylene Cup (E157)
Personnel Required:
Aircraft Structural Repairer
Inspector
References:
TM 55-1520-240-23P
General Safety Instructions:
Sealant may irritate skin and cause
burns. Avoid contact with skin, eyes
and clothing. In case of contact,
immediately flush skin or eyes with
plenty of water for at least 15 minutes.
Get medical attention for eyes.
Do not use more than 30 psi
compressed air for cleaning purposes.
Debris propelled under pressure can
cause injury to eyes. Use source of
compressed air under 30 psi and
eye protection to prevent injury to
personnel.
NOTE
Procedure is same to install any
tiedown receiver. There is one
tiedown receiver on the underside of
each rotary-wing blade.
1.
Clean receptacle (1). Use compressed air. Wear
goggles to protect eyes.
5-455
