TM 55-1520-240-23-10
16-104
INSTALL EAPS CONTROL PANEL COMPONENTS
16-104
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electrical Repairer’s Tool Kit, NSN 5180-00-323-4915
Materials:
None
Personnel Required:
Aircraft Electrician
References:
TM 55-1520-240-23P
TM 55-1520-240-T
INSTALL SWITCHES AS FOLLOWS:
1.
Remove top nut (12), lockwasher (13), and
locking ring (14) from the serviceable switch (8).
2.
Adjust locknut (15) to same position as on
removed switch (8).
3.
Insert switch (8) through back of panel (4). Install
lockring (14), lockwasher (13), and nut (12) from
front of panel.
4.
Install wires (11), washers (10), and screws (9)
on switch (8). (Refer to TM 55-1520-240-T.)
Remove tags.
INSTALL LIGHT RECEPTACLE AS FOLLOWS:
5.
Insert receptacle (22) in panel (4).
6.
Install ground lug (21), lockwasher (20), and nut
(19) on receptacle (22).
7.
Install wire (18), washer (17), and screw (16).
Remove tag.
There may be an unlighted lightplate
installed at this time. However, if
a lighted panel is installed, caution
should be used when replacing it to
avoid damage to the light connector
(3). A white cross (5) on face
of lightplate indicates location of
electrical connector.
8.
Position panel (4) on overhead panel (7). Turn
fasteners (6) 1/4 turn clockwise to secure panel.
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
16-359
