TM 55-1520-240-23-10
16-101
REMOVE POWER DISTRIBUTION PANEL (PDP), EXTENSION BOX, AND CIRCUIT
BREAKERS
16-101
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electrical Repairer’s Tool Kit, NSN 5180-00-323-4915
Materials:
None
Personnel Required:
Aircraft Electrician
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Pressure Off
NOTE
No. 2 PDP extension box shown.
Procedure is similar to remove
extension box and circuit breakers
from No. 1 PDP.
1.
Loosen eight fasteners (1) and remove the door
(2).
2.
Tag and disconnect wires (3) by removing screws
(4) and washers (5).
3.
Remove the nuts (6) and circuit breakers (7).
4.
Loosen six fasteners (8) and open door (9).
5.
Remove screw (10), washer (11), and clamp
(12). Remove screw (13), washer (14), nut (15),
clamp (16).
6.
Remove five screws (19), washers (20), and nuts
(21). Remove five screws (22), washers (23). Lift
box (18) off PDP (24).
7.
If No. 1 extension box is being replaced, remove
bulb stowage box.
FOLLOW-ON MAINTENANCE:
As Required
END OF TASK
16-356
