TM 55-1520-240-23-10
16-59.28 BONDING CHECK OF ELECTRICAL COMPONENTS
16-59.28
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electronic Equipment Tool Kit,
NSN 5180-00-064-5178
Biddle Ohmmeter (T7) or Equivalent
Materials:
Cloths (E135)
Gloves (E184.1)
Naphtha (E293)
Goggles (E473)
Personnel Required:
Avionics Mechanic
Aircraft Electrician Inspector
Inspector
Equipment Condition:
As Required
WARNING
Aliphatic naphtha (E293) is
combustible and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
1.
Clean bonding and grounding surface thoroughly
before installing components. Use naphtha
(E293) and cloths (E135). Wear gloves (E184.1)
and goggles (E473).
2.
Install components and bonding straps, (if
applicable) per installation procedures of
components. Do not install connectors. Perform
bonding check. Use biddle ohmmeter (T7) or
equivalent to test the resistance between the
cleaned surfaces and aircraft ground. Resistance
shall be 0.0025 ohms or less.
3.
Refinish exposed surfaces in accordance with
applicable corrosion control directives.
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
16-250.48
Change 1
