TM 55-1520-240-23-10
16-59.16 REMOVE AN/ALE-47 DISPENSER ASSEMBLY
16-59.16
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electronic Equipment Tool Kit,
NSN 5180-00-064-5178
Materials:
Paper Tag (E264)
Personnel Required:
Avionics Mechanic
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
AN/ALE-47 Safety Switch Pin Installed
(TM 1-1520-240-10)
LDG GR SW Bypass Switch in Normal
(TM 1-1520-240-10)
General Safety Instructions:
WARNING
Ensure battery is disconnected and
electrical power is off. Ensure LDG
GR SW BYPASS switch on landing
gear bypass panel is in NORMAL
and AN/ALE-47 safety switch pin is
installed. Failure to comply could
result in death or injury to personnel
or damage to equipment.
NOTE
Procedures to remove all dispenser
assemblies are the same.
1.
Remove both payload modules per Task
16-59.12.
2.
Tag, cap and disconnect electrical plug (3) from
fuselage connector (4).
3.
Disconnect protective cap (2) from stowage
receptacle (1); install cap on fuselage connector
(4).
16-250.32
Change 1
