TM 55-1520-240-23-10
16-59.17 INSTALL AN/ALE-47 DISPENSER ASSEMBLY (Continued)
16-59.17
NOTE
Procedures to install all dispenser
assemblies are the same.
Install connectors/plugs per the
following:
CONNECTOR
OR PLUG
LOCATION
J41
LH Fuselage Upper
J44
LH Fuselage Lower
J47
RH Fuselage Upper
J50
RH Fuselage Lower
P42
LH Upper Dispenser # 3
P45
LH Lower Dispenser # 1
P48
RH Upper Dispenser # 4
P51
RH Lower Dispenser # 2
1.
Position dispenser assembly (8) on mount (2);
install four bolts (10) and washers (9).
CAUTION
An over-torque of bolts can cause
a failure in retaining the dispenser
assembly during flight and flare
dispensing.
2.
Torque bolts (10) to 60 inch-pounds.
3.
Perform bonding check of electrical components
per Task 16-59.28.
4.
Connect electrical plug (7) to dispenser assembly
connector (1).
5.
Install bolts (4), washers (5), and nuts (6) onto
dispenser assembly arms (3).
6.
Remove protective cap (12) from connector (14);
install cap on receptacle (11).
7.
Install electrical plug (13) onto fuselage
connector (14).
8.
Install payload modules per Task 16-59.13.
INSPECT
FOLLOW-ON MAINTENANCE:
Perform operational check of countermeasures
dispenser system (TM 55-1520-240-T).
END OF TASK
Change 1
16-250.35
