TM 55-1520-240-23-10
16-59.10 REMOVE AN/ALE-47 SAFETY SWITCH
16-59.10
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electronic Equipment Tool Kit,
NSN 5180-00-064-5178
Materials:
Paper Tag (E264)
Personnel Required:
Avionics Mechanic
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
CAUTION
Support safety switch while removing
screws. Failure to comply may result
in damage to programmer.
1.
Disconnect, tag and cap two electrical connectors
(6), from J1 and J2 receptacles on AN/ALE-47
safety switch (5).
2.
Remove safety pin (1) from safety switch (5).
3.
Remove three screws (2) and washers (3)
securing safety switch (5) to mounting bracket
(4).
4.
Slide safety switch (5) out of mounting bracket
(4).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
16-250.20
Change 1
