TM 55-1520-240-23-10
16-7.1
ASSEMBLE CENTER CARGO HOOK (AVIM)
(Continued)
16-7.1
31.
Rotate synchronizer arms (50 and 56) over holes
in cams (25 and 26). Install two bushings (69)
and bolts (70) through forks, in synchronizing
arms into cams.
32.
Adjust keeper stop (71) as follows:
a.
Remove lockwire from locknut (72). Loosen
locknut.
b.
Adjust keeper stop (71) so that keeper
contacts or is within 0.06 inch of hook (1).
c.
Tighten locknut (72). Lockwire locknut. Use
lockwire (E231).
33.
Adjust cam stops (21) as follows:
a.
Lift lever (65) and rotate cams (25 and 26)
until they contact stop screws (73).
b.
Loosen locknuts (74).
c.
Adjust stop screws (73) until lower edge of
cut out in cams (25 and 26) is 0.01 to 0.09
inch above lower edge of cut out in formers
(13 and 14).
d.
Tighten locknuts (74).
16-64
