TM 55-1520-240-23-10
16-7.1
ASSEMBLE CENTER CARGO HOOK (AVIM)
(Continued)
16-7.1
10.
Install three bolts (31) and support block (32) on
former (14). Do not tighten bolts at this time.
11.
Insert one end of shaft (33) in bearing (12).
12.
Position actuating cylinder (2), so that machined
spindle on hook (1) fits into slot in cam (26).
Do not hammer alignment pin into
former. If end of pin becomes
enlarged, it will not fit in actuator
support.
13.
Install alignment pin (34) in former (13). Use
arbor press.
14.
Position former (13) on actuating cylinder (2) so
that shaft (33) aligns with bearing (11), alignment
pin (34) engages actuator support (10) and
machined spindle on hook fits into slot in cam
(25).
15.
Lightly tap former (13) into place with plastic or
fiber mallet.
16.
Install three bolts (31) through former (13) into
support block (32). Do not tighten bolts at this
time.
17.
Install two bearings (35) (TM 55-1500-322-24).
18.
Position block (36) between formers (13 and 14).
Install three bolts (37), washers (38), and nuts
(39). Do not tighten nuts at this time.
19.
Align holes in formers (13 and 14) and actuator
support (10). Install bolt (40), washer (41), and
nut (42). Do not tighten nut at this time.
16-61
