TM 55-1520-240-23-10
16-6
INSPECT CENTER CARGO HOOK PARTS AVIM
16-6
INITIAL SETUP
Applicable Configurations:
All
Tools:
Technical Inspector Tool Kit, NSN 5180-00-323-5114
Multimeter
Materials:
None
Personnel Required:
Inspector
References:
TM 55-1500-322-24
TM 1-1520-254-23
Equipment Condition:
Off Helicopter Task
Center Cargo Hook Disassembled (Task 16-5 Without
35 ) (Task 16-5.1 With 35 )
NOTE
Inspection steps cover parts that are
subject to wear.
1.
Check synchronizer tube (1), two bushings (2),
and two synchronizer arms (3) for bending and
distortion.
2.
Measure diameter of tube (1). Diameter shall not
be less than 0.409 inch.
3.
Measure inside and outside diameters of
bushings (2). OD shall not be less than 0.718
inch. ID shall not be more than 0.410 inch.
4.
Measure width of slot (3) and diameter of hole
(4) in two arms (5). Width shall not be more than
0.321 inch. Diameter shall not be more than
0.721 inch.
16-47
