TM 55-1520-240-23-10
16-5.1
DISASSEMBLE CENTER CARGO HOOK (AVIM)
(Continued)
16-5.1
11.
Remove hose (41) from actuating cylinder (42).
12.
Remove nut (43), washer (44), and bolt (45) from
actuating cylinder support (46).
NOTE
Do not remove bearings unless they
are worn.
13.
Remove three nuts (47), washers (48), and bolts
(49) from block (50). Remove block from formers
(51 and 52). Remove two bearings (53) (TM
55-1500-322-24).
14.
Remove two springs (54) from eyebolts (55) and
levers (56 and 57).
15.
Remove two nuts (58), washers (59), and
eyebolts (55) from formers (51 and 52).
16.
Remove two nuts (60), washers (61), levers (56
and 57), and cams (62 and 63) from shaft (64).
17.
Remove two bolts (65) and bushings (66).
18.
Remove two nuts (67), washers (68), and bolts
(69) from synchronizer arms (70 and 71).
19.
Remove two synchronizer arms (70 and 71),
bushings (72), and tube (73) from formers (51
and 52).
16-44
