TM 55-1520-240-23-10
14-3
ADJUST WINCH LIMIT SWITCHES
(Continued)
14-3
REMOVE WINCH HOUSING COVER
NOTE
It is not necessary to remove cover to
adjust out-limit switch.
1.
Remove lockwire. Remove six screws (1) and
washers (2).
2.
Lift cover (3) just enough to reach spring (4).
Detach spring from underside of cover at bracket
(5).
3.
Remove cover (3).
4.
Cut tie wrap and remove spring (4) from wire
bundle (6).
ADJUST OUT-LIMIT SWITCH
5.
Set shift lever (7) to RESCUE.
6.
Have helper keep slight pull on cable (8) as cable
reels out. Helper must wear gloves (E185).
7.
Reel out cable (8) until only 2-1/2 wraps are left
on drum (9) (TM 55-1520-240-T).
8.
Loosen nut (10). Turn screw (11) in or out of
lever (12) until it clicks.
9.
Apply light coat of sealant (E330) to thread of
screw (11). Tighten nut (10) to lock screw in
place.
INSPECT
10.
If no other switches need to be adjusted, go to
step 42.
14-11
