TM 55-1520-240-23-10
14-3
ADJUST WINCH LIMIT SWITCHES
(Continued)
14-3
17.
Remove four bolts (15) and washers (16). Move
winch (17) enough to gain access to switch (18).
18.
Loosen two screws (19). Position switch (18) in
slots of switch bracket (20) so that it is actuated
by striker bracket (21).
19.
Apply light coat of sealant (E330) to thread of
screws (19). Tighten screws.
20.
Deleted.
INSPECT
21.
If no other switches need adjusting, position
winch (17) and install four bolts (15) and washers
(16). Go to step 31.
ADJUST CARGO MODE IN-LIMIT SWITCH
22.
Set shift lever (7) to CARGO.
23.
Have helper keep slight pull on cable (8) as it
reels out. Helper must wear gloves (E185).
24.
Reel out 5 feet of cable (8) (TM 55-1520-240-T).
25.
Mark cable (8) 36 inches from ball end (13). Use
marking pencil (E271).
14-13