• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DISASSEMBLE  THRUST  CCD ACTUATOR (AVIM) (Continued)
ASSEMBLE  THRUST  CCD  ACTUATOR  (AVIM)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  628    629    630    631    632  633  634    635    636    637    638  
TM  55-1520-240-23-9 11-156 INSPECT  SERVO OR  TRIM  MOTOR  (AVIM) 11-156 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Electrical  Tool  Kit,  NSN  5180-00-323-4915 Dial  Indicator,  0  to  0.030  Inch Dial  Indicating  Scale,  0  to  50  Pounds Vise,  Soft  Jawed Materials: None Personnel  Required: Avionics  Mechanic Inspector Equipment  Condition: Off  Helicopter  Task 1. Clamp  motor (1) in  vise  (2). 2. Apply  1 pound  inward  to  end  of shaft (3).  Use dial  indicating  scale.   Remove  scale. 3. Mount indicator (4) so  that  movable  arm  contacts end  surface  of shaft (3).   Align  with  shaft  axis. Set  indicator to  zero. 4. Apply  about  2  pounds  a  outward  on  shaft (3).   Pull  shaft  by  hand.   Check  indicator (4) movement.   Indicator  must  not  indicate  more than  0.006 inch. 5. Remove  indicator (4). 6. Remove  motor  (1)  from  vise  (2). INSPECT FOLLOW-ON MAINTENANCE: None END  OF  TASK 11-639







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.