• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  THRUST CONTROL (COPILOT) (Continued) - TM-55-1520-240-23-9_322
INSTALL  THRUST CONTROL (COPILOT) (Continued) - TM-55-1520-240-23-9_324

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  298    299    300    301    302  303  304    305    306    307    308  
TM  55-1520-240-23-9 11-67 INSTALL THRUST  CONTROL (COPILOT) (Continued) 11-67 6. Remove  nut  (14),  washers (15),  and  bolt  (16) from  bellcrank  (17).  Make  sure  bushings (18) are in  place  in  bellcranks. 7. Position  thrust  control  bottom  link  (19)  in bellcrank  (17).   Install  bolt  (16),  head  outboard, two  washers (15), and  nut (14).  Torque  nut to  30 to 45 inch-pounds.  Install  cotter pin  (20). 8. Check  bolt  (16).   Bolt  shall  not  rotate  with  a torque  less  than  10 inch-pounds.  Bolt  shall  not have  axial  looseness.  If bolt  rotates  or is  loose, add  washer  under  nut.   Torque  and  cotter pin nut  again. INSPECT 9. Connect  electrical  connector (21) to  receptacle (22) on  bulkhead  (23). 10. Install  cable  clamp  (24)  to  structure  (25)  and screw  (26). INSPECT 11-307







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.