• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL THRUST CONTROL (PILOT) (Continued) - TM-55-1520-240-23-9_317
INSTALL THRUST CONTROL (PILOT) (Continued) - TM-55-1520-240-23-9_319

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  293    294    295    296    297  298  299    300    301    302    303  
TM  55-1520-240-23-9 11-66 INSTALL  THRUST  CONTROL (PILOT) (Continued) 11-66 Acetone  (E20)  can  form  toxic vapors  if  exposed  to  flares.   Use  in well-ventilated  area,  away from  open flame.  In  case  of contact,  immediately flush  skin  or  eyes  with  water  for at  least  15  minutes.   Get  medical attention  for eyes. 12. Clean old  sealant from flange  (28) of landing  light housing  assembly  (29).   Use  acetone  (E20) and cloths  (E120).  Clean  old  sealant  from  inside  of flange  (30).   Wear gloves  (E186). Sealant  (E336) can  irritate  skin  and cause  burns.  Avoid  contact  with  skin, eyes,  and  clothing.  In  case  of  contact, immediately  flush  skin  or eyes  with water for  at  least  15 minutes.   Get medical  attention  for eyes. 13. Apply  sealant  (E336) to  both  sides  of  gasket (31).  Install  gasket  on  flange  (28).   Wear gloves (E186). 14. Tilt  housing  assembly (29) to  one  side  and  guide it  up  and  inside  structure  (30).   Make  sure  lamp (32)  is  aft. 15. Connect  electrical lead  (33) to  stud  (34).  Install washer (35)  and  nut  (36). 11-302







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.