• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PAINT  THRUST CONTROL (Continued)
REMOVE  COPILOTS  PITCH AND  ROLL CONTROL STICK

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  303    304    305    306    307  308  309    310    311    312    313  
TM  55-1520-240-23-9 11-69 REMOVE  PILOT’S  PITCH  AND  ROLL CONTROL  STICK 11-69 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Materials: None Personnel  Required: Medium  Helicopter  Repairer Equipment  Condition: Battery Connected  (Task  1-39) Electrical  Power  On Hydraulic  Power  On Pilot’s  Seat  Fully  Aft  (Task  2-115) Control Stick  Boot Removed  (Task 2-81) Pilot’s  Forward  Right  Floor  Cover  Removed  (Task 2-81) 1. Remove  three  screws (1)  from  three  clamps (2). Remove  cable  (3)  from  clamps.   Install  clamps and  screws loosely  in  control  assembly (4). 2. Disconnect  connector  (5)  from  receptacle  (6)  on right of  control  assembly  (4). 3. If  applied, remove  silicone  rubber  coating  from cotter  pin  (7)  and  nut  (8).  Remove  cotter  pin, nut, washer  (9), clamp  (14), and  bonding  jumper  (12) from bolt (10)  in socket (11).  Remove  clamp  from cable  (3). 4. Remove  bolt  (10), and  washer  (3)  from  socket (11).  Disconnect  bonding  jumper  (12)  from  bolt and  cable  (3).   Cut ties. 5. Disconnect  pitch  and  roll  control  stick (15)  from socket  (11).  Twist and  pull stick forward.  Remove stick  and  cable  (3). 6. Install  bolt (10), washer  (13),  clamp  (14), washer (9),  and  nut  (8)  loosely in  socket (11). FOLLOW-ON  MAINTENANCE: None END  OF  TASK 11-312







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.