TM 55-1520-240-23-4
5-61
INSTALL CENTRIFUGAL DROOP STOP SUPPORT AND BLOCKS
(Continued)
5-61
5.
Position interposer block (8) on support (9).
Install two screws (10). Lockwire screws
together. Use lockwire (E229).
NOTE
If support is attached to arm before
primer is completely dry, interposer
will not spring back.
6.
Prime contact surfaces of support (9) and
balancing arm (11). Use two even coats of epoxy
primer (E29.1). Allow to dry completely. Wear
gloves (E184.1).
7.
Install interposer support (9) as follows:
a.
Position support (9) on arm (11) over two
bolts (12).
b.
Install washers (13) and nuts (14). Do not
tighten nuts completely.
5-263