• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  CENTRIFUGAL DROOP  STOP  SPRINGS  AND  WEIGHTS
INSTALL CENTRIFUGAL DROOP STOP  SPRINGS  AND WEIGHTS (Continued) - TM-55-1520-240-23-4_272

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  245    246    247    248    249  250  251    252    253    254    255  
TM  55-1520-240-23-4 5-57 INSTALL CENTRIFUGAL DROOP STOP  SPRINGS  AND WEIGHTS (Continued) 5-57 Do  not apply epoxy primer (E292) to screw thread.  Torque  will be  incorrect. NOTE There  are  three  centrifugal  droop stops.   Procedure  is  same  to  install springs and  weights on any centrifugal droop  stop. 1. Prime  mating  surfaces  of  balancing  arm  (1) and weight  (2).  Prime  grip  of screws (3).  Use  epoxy primer (E292).  Wear  gloves  (E184.1). 2. Position  weight  (2)  on  arm  (1).   While  primer is wet,  install  screws  (3),  washers (4), and  torque collars  (5).   Turn  torque  collars  until  tops  (6) break  off.  Use  screw  key  to  prevent screws from turning. 3. Install  two  grommets  (7)  in  ends  of  extension spring  (8). 4. Hook  limiter springs  (9) together and  position limiter springs  in  extension  spring  (8). 5. Install  extension  spring  (8) and  outboard  limiter spring  (9) on  lugs (10) as  follows: a. Position  bearing  (11)  in  grommet  (7)  and ends  of  limiter spring  (9). b. Position  two  washers  (12)  over  ends  of bearing  (11). c. Position  bearing  (11) between  lugs  (10). d. Install  bolt  (13),  head  toward  pitch-varying housing  (14),  through  lugs (10)  and  bearing (11). e. Install  nut  (15).   Torque  nut  to  12  to  15 inch-pounds.   Install  cotter pin  (16).   Use washers (17) if  needed  to  align  cotter pin. 5-251







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.