• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  POWER TURBINE CONTROL LINKAGE (Continued)
REMOVE  POWER TURBINE  CONTROL ACTUATOR

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  647    648    649    650    651  652  653    654    655    656    657  
TM  55-1520-240-23-3 4-137 REPLACE  POWER  TURBINE  RPM  LIMITING STOP 4-137 INITIAL  SETUP Applicable Configurations: Without    74 Tools: Powerplant   Repairer’s  Tool  Kit,   NSN 5180-00-323-4944 Materials: Lockwire  (E229) Personnel  Required: Aircraft  Powerplant  Repairer Inspector References: TM  55-1520-240-23P Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Engine  Work  Platform  Open  (Task  2-2) Engine  Access  Cover Open  (Task 4-49) NOTE Procedure  is  same  to  replace  power RPM  Limiting  Stop  on  No.  1  or  No.  2 engine.  No.   1  engine  is shown. Power  Turbine  control  linkage  omitted for  clarity. 1. Cut  lockwire  and  remove  stop  (1). 2. Install  new stop  (1)  and  lockwire.  Use  lockwire (E229). INSPECT FOLLOW-ON MAINTENANCE: Close  engine  access cover (Task  4-50). Close  engine  work  platform  (Task  2-2). END  OF  TASK 4-449







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.